Raymarine 150/400 Manuel d'installation télécharger pdf (Page 31)

Chapter 2: SmartPilot Commissioning 23

Step 4 - Adjust key SmartPilot settings

The next step in the commissioning process requires the adjustment of some

key settings. To achieve this you will need to enter one of the four calibration

modes, Dealer Calibration. For more information on the various calibration

modes and their uses see page 39.

Enter Dealer Calibration mode

As improper use of the Dealer Calibration settings can seriously impair

SmartPilot performance, we have made entry to the Dealer Calibration mode

more difficult. Ensure you follow the instructions in this step carefully.

1. Start with the SmartPilot in STANDBY mode.

2. Enter DEALER CAL as follows:

Note: For more information on SmartPilot settings, refer to Chapter 3:Ad-

justing SmartPilot Settings

ST6001 Controllers ST7001 and ST8001 Controllers

• press and hold the standby key for two

seconds to enter the Calibration mode

• when the screen shows DISPLAY CAL,

press the disp key until you see the

DEALER CAL screen

•press the auto key: the display will

change to CAL ?

•press -1 and +1 together to enter Dealer

Calibration mode

• press and hold the standby key for two

seconds to enter the Calibration mode

• when the screen shows DISPLAY CAL,

press the disp, up or down arrow

key until you see the DEALER CAL screen

• press the auto key: the display will

change to CAL ?

•press -1 and +1 together (ST7001) or

press up and down arrow keys

together (ST8001)

to enter Dealer Calibration mode

At the CAL ? screen, press + together to enter DEALER CAL

2 sec

L ?

-1 +1

D6322-1

(ST8001 only)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 79 80

Pas de commentaire

Raymarine 150/400 Manuel d'installation Page 31