Raymarine 150/400 Manuel d'installation télécharger pdf (Page 6)

vi SmartPilot Commissioning Guide

• Raymarine specified cables are used. Cutting and rejoining these cables

can compromise EMC performance and must be avoided unless doing so

is detailed in the installation manual.

• If a suppression ferrite is attached to a cable, this ferrite should not be

removed. If the ferrite needs to be removed during installation it must be

reassembled in the same position.

EMC suppression ferrites

The following illustration shows typical cable suppression ferrites used with

Raymarine equipment. Always use the ferrites supplied by Raymarine.

Connections to other equipment

If your Raymarine equipment is to be connected to other equipment using a

cable not supplied by Raymarine, a suppression ferrite MUST always be

attached to the cable near to the Raymarine unit.

Handbook information

To the best of our knowledge, the information in this handbook was correct

when it went to press. However, Raymarine cannot accept liability for any

inaccuracies or omissions it may contain. In addition, our policy of

continuous product improvement may change specifications without notice.

As a result, Raymarine cannot accept liability for any differences between

the product and the handbook.

D3548-5

1 2 3 4 5 6 7 8 9 10 11 ... 79 80

Pas de commentaire

Raymarine 150/400 Manuel d'installation Page 6