Chapter 2: SmartPilot Commissioning 21
NMEA navigator connections
If you have connected the SmartPilot to a NMEA navigator, check the links
by displaying the default navigation data pages on the SmartPilot controller:
•press disp to display the first data page (XTE), and check that this page
shows the expected data.
•press disp again to check each successive data page (BTW/DTW)
If the display shows dashes instead of data values, check for the following:
• the navigator is not switched on or not transmitting an active waypoint
• a cabling error. Check for open circuit, short circuit or reversed wires
• the navigator is not configured to transmit the required data format
Wind instrument connections
• if the controller does not display WIND mode, the SmartPilot is not receiv-
ing wind data. Check the wind instrument and connections.
ST6001 Controllers ST7001 and ST8001 Controller
• If you have connected the SmartPilot to a
NMEA or SeaTalk wind instrument, check
the links by pressing standby and auto
together:
• the SmartPilot should display the Wind
Vane mode screen, with the locked wind
angle and locked heading.
• If you have connected the SmartPilot to a
NMEA or SeaTalk wind instrument, check
the links by pressing the wv button
• the SmartPilot should display the Wind
Vane mode screen, with the locked wind
angle and locked heading.
D6382-1
+
ST6001
ST7001
ST8001
wv
standby auto
Commentaires sur ces manuels