Raymarine 150/400 Manuel d'installation télécharger pdf (Page 28)

20 SmartPilot Commissioning Guide

Step 1 - Switch on

1. When you have installed your SmartPilot system, switch on the main

power breaker.

2. If the SmartPilot controller and computer are active, the controller will

beep, show the controller type for a few seconds will show the STANDBY

screen.You may see a CALIBRATE REQUIRED message. This is displayed

for a short time if either:

• the vessel type is not selected

• the compass is not calibrated

These will be calibrated later in this chapter.

3. Check that the STANDBY screen displays a live compass heading and a

rudder angle.

Troubleshooting

• If the SmartPilot controller does not beep or the display is blank, check

the fuse/circuit breaker and the SeaTalk fuse in the SmartPilot computer.

• If the display shows the SEATALK FAIL or NO DATA alarm message, check

the SeaTalk connections.

•If the STANDBY screen does not display a live compass heading or a rud-

der angle, check the sensor connections.

Step 2 - Check the SeaTalk and NMEA connections

SeaTalk connections

If you have connected the SmartPilot controller to other existing SeaTalk

instruments or controllers, check the links as follows:

1. Select display lighting level 3 (LAMP 3) on one of the other SeaTalk

instruments or controllers.

2. The SmartPilot should immediately switch on its display lighting:

• if the lighting does not switch on, check the SeaTalk cabling between

the SmartPilot and the other units.

D3567-5

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Pas de commentaire

Raymarine 150/400 Manuel d'installation Page 28