Raymarine 150/400 Manuel d'installation télécharger pdf (Page 25)

Chapter 1: System Connections 17

1.10 Secure the cables

S1 systems

To prevent strain on the connector blocks, secure the cables to the SmartPilot

computer with cable ties as shown below.

S2 and S3 systems

When you have connected all autopilot system components, we recommend

that you use the supplied cable clamp to relieve any strain on the cable

connections.

Secure the cables with the cable clamp as follows:

1. Hold the cable clamp in place below the computer, making sure:

• its center hole is below the center of the computer (i.e. in line with the

connector cover catch)

• it is at least 50 mm (2 in) from the bottom of the computer

• the hole locations are clear of any cables

2. Mark the position of the three holes, then remove the cable clamp.

3. Drill the three pilot holes using a 3 mm (

in) drill bit.

D6321-1

SmartPilot

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

Pas de commentaire

Raymarine 150/400 Manuel d'installation Page 25