Raymarine 150/400 Manuel d'installation télécharger pdf (Page 24)

16 SmartPilot Commissioning Guide

Connecting spool valves (S2 and S3 only)

If the drive has spool valves, connect them to the motor and solenoid

terminals on the computer as shown below. The computer provides a

negative ground for the spool valves even when it is switched off.

CAUTION:

Do NOT connect the solenoid return cables to boat’s negative ground, as

this will bypass the current protection devices inside the SmartPilot

computer.

Selecting clutch voltage (S3 & S3G only)

Note: All Raymarine 12 V and 24 V drive units with a clutch have a 12 V

clutch so you do NOT need to re-position the clutch fuse.

You can use the S3 and S3G SmartPilot computers with other manufacturers’

drives that have either 12 V or 24 V clutches.

Select the appropriate clutch voltage by positioning the clutch fuse to the left

(12 V clutch) or right (24 V clutch).

12 V

24 V

D5397-2

Spool valves

(diodes across

spool valves)

SmartPilot 150/400 connections

Return cables

Diodes

Electronic steering

or jog lever

If electronic steering or jog lever is

used on the same solenoids, fit

diodes (suggested type: 1N4004)

as indicated to prevent

backfeeding the course computer.

D5398-2

Fuse position: 12 V clutch Fuse position: 24 V clutch

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 79 80

Pas de commentaire

Raymarine 150/400 Manuel d'installation Page 24