Raymarine SeaTalk2 Guide d'installation télécharger pdf (Page 25)

Chapter 2: Installing the system 17

Fitting to 3/4 inch steering shaft

To fit the Sport Pilot drive to a

inch steering shaft, refer to the illustration above and:

1. Ensure that the taper adaptor fitted under

Prepare to fit torque restraint

(above), is

still in place

on the steering shaft.

2. Insert the larger of the two woodruff keys supplied into the drive shaft keyway. If

necessary, use a small hammer to lightly tap the key into position.

3. Slide the SPX-5 Sport Drive onto the shaft so that the woodruff key inserted at step

2 engages with the keyway in the drive.

Note:

Do NOT use the original wheel nut and washer to secure the Sport Drive.

4. Place the

inch seal washer (supplied) on the shaft so that the seal side is

towards the Sport Drive.

5. Use the box spanner supplied to secure the drive unit with the

inch nylock nut

supplied.

6. With the steering still hard over to starboard, tighten the drive unit securing nut to

22 pound feet (30 Newton meters).

7. Offer up the stub shaft to the drive unit, ensuring the alignment marks on the stub

shaft and drive unit are aligned. Using the Allen key supplied, secure the stub

shaft to the drive with the four countersunk screws supplied.

8. Insert the smaller of the two woodruff keys supplied into the keyway on the stub

shaft. If necessary, use a small hammer to lightly tap the key into position.

Woodruff

key (large)

Woodruff

key

(small)

Alignment

mark

Alignment

mark

Screw

Washer

Seal

washer

Sport Drive

Taper

adaptor

Stub shaft

Nyloc

nut

(small)

Nyloc nut

(large)

3/4"

shaft

D10669-1

3/4 inch shaft fitting

87076_1.book Page 17 Monday, March 10, 2008 2:57 PM

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Raymarine SeaTalk2 Guide d'installation Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Navigateurs Raymarine SeaTalk2