Raymarine 150/400 Manuel d'utilisateur télécharger pdf (Page 12)

4 Type 150/400 Autopilot System: Installation Guide

Step 1

• handheld remotes (the ST600R full-function remote control or

the SeaTalk handheld remote control)

• pushpit or masthead wind vanes (for sail boats without a suitable

wind instrument)

• an external alarm (through an E85001 interface)

1.2 Obtain installation tools

To install the core pack you will need the following items:

• tape measure (metric/imperial)

• screwdrivers:

• cross-head/pozi-drive

• flat-bladed (large and small)

• drill and 3 mm drill bit

• center punch, pencil and masking tape

• for the rudder position sensor:

• hacksaw

• small adjustable spanner

• bolts, nuts and lockwashers (if required for tiller pin)

• for the course computer power supply:

• suitable power cable (see page 16)

• suitable fuse/circuit breaker (see page 16)

Note: You will also need the tools and equipment required to install

the control unit and drive unit. For full details, refer the information

supplied with control unit and drive unit.

1.3 Check parts supplied

Use the diagram on the following page to check the parts supplied.

CAUTION:

Before you start installing the course computer, check that it is

the correct voltage for your boat’s power and your drive unit.

For more information about extended systems, see page 31.

81173_3.book Page 4 Thursday, June 7, 2001 11:51 AM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Pas de commentaire

Raymarine 150/400 Manuel d'utilisateur Page 12