Raymarine SmartPilot SPX-30 Manuel d'installation Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
Chapter 2: Commissioning procedures 9
To set the required units:
1. Use < and > to select the type of data you want to change, i.e. Speed, Depth,
Distance etc.
2. Press
ENTER
, to display the setup page for the units you have selected.
3. Use < and > to select the required units.
4. Press
ENTER
, to save the units setting and return to the
Units
setup menu.
5. Repeat steps 1 to 4 for all data types you want to set.
Leaving units setup
When all units are set to your preferences, display the
Units
menu, then:
1. Use < and > to select the
Continue
option.
2. Press
ENTER
, to complete initial setup.
3. Press
ENTER
to leave Initial Setup and proceed to the first calibration page.
Note: If necessary, the initial setup values can be changed later, via the Main Menu.
2.2 Dockside calibration
When the initial setup is complete, the ST70
autopilot controller will determine whether the
SmartPilot X has been calibrated. If it has, you may
begin to use your ST70 immediately. If not, the on
screen wizard will then take you through the
calibration process, starting with dockside
calibration.
If the system has already been calibrated but you
wish to repeat the process, you can run the Setup
Wizard from the Advanced Options menu, accessible from the main menu.
WARNING: Ensure proper control
For proper control of your boat, you MUST complete the dockside checks
before starting the initial seatrial.
With the boat still safely tied up, use these dockside calibration instructions to:
Set up the drive.
Check the rudder.
Check motor phasing (test the drive).
Note: You may exit the calibration process at any time by pressing
CANCEL
on your ST70 con-
troller. The next time you power up, you will be prompted to complete calibration.
Press ENTER to continue.
Dockside Calibration
D10886-1
Before you can use
your autopilot you
need to do some
dockside checks.
Press CANCEL to
exit without saving.
81287_1.book Page 9 Tuesday, March 18, 2008 11:50 AM
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Commentaires sur ces manuels

Pas de commentaire